Week 50 This week see the start of the funnels

The bits we received

And what we did with them

There's a few of things to watch out for here.  Firstly, the 2 funnels slightly different heights, so make sure you mark them 1 & 2 correctly.

Secondly, one of the frames for each funnel is slightly longer than the other 2.  This is the one sitting at a slight angle rather than square.

Thirdly, the slots in my set of parts are too wide. This is not a problem, but just make sure you offset the gap to the same side on each frame and make sure the frames are square and the slots all line up.  Nothing difficult, at all this week.

Hot tip of the week

The funnels are almost, but not quite identical.  Make sure you measure carefully and number them where the numbers can be seen.  Be careful when you sand the bottom of the funnels.  Re-write the number before you mix them up.

How many hours does it take to build the model ??

This week :

1 hr

Running total :

174 hrs

Take me to week 51